Hoover POWER PATH Owner's Manual page 11

CLEANING UPHOLSTERY
Read "Before You Begin Cleaning" instructions.
Be sure to check Hoover Cleaning Guide on page 6 and the
cleaning code on your upholstery. Use your cleaner only on
upholstery marked "W" or "W/S".
1. Attach hose and solution tube as instructed.
2. Place handle in upright position. Brushes will not rotate
while handle is in upright position.
3. Fill Clean Water Tank according to instructions
on (Pg. 7).
4. Attach tool to end of hose.
5. Dry hands and plug cleaner into a properly
grounded outlet.
6. Turn cleaner ON.
7. 4.9 Gently press the tool onto the fabric. Press the
trigger and slowly pull the nozzle over the
fabric.
8. Overlap strokes by 1/2 inch to help prevent
streaking.
9. Make additional strokes without pressing the
trigger to remove more solution.
To clean in corners or creases, lift the tool one
half inch from the fabric and press the solution
trigger.
10. 4.10 For heavily soiled areas, it may be necessary
to repeat the cleaning process.
crisscrossing strokes to the original pattern;
overlap each pass.
Make no more than 2 passes with the solution
over any one area to prevent over-wetting and
damage to fabric.
11. For best cleaning results, Hoover recommends to
rinse the upholstery with water only. This will remove
residual cleaning solution from your upholstery.
Simply fill your clean water tank with water
only and repeat steps 7 and 8.
If additional cleaning is necessary, wait until the upholstery
is completely dry before using the tool again.
Empty Dirty Water Tank when the motor sound becomes
higher pitched and there is a loss in suction (see
"Automatic Shut-Off").
When finished cleaning, follow "After Cleaning" and "After
Using Tool" instructions.
4.9
4.10
Make
11