Ready To Drive; Service Engine Soon; Stability Control Off; Stop Safely - Ford C-MAX HYBRID 2015 Owner's Manual

Note: If your vehicle detects certain faults,
it will not allow you to operate the
accelerator pedal. If this happens, press the
brake pedal and release it. This will activate
limp home vehicle operation. In limp home
vehicle operation, your vehicle will
accelerate in a controlled manner up to a
maximum speed of 35 mph (56 km/h) on
a flat surface. If you apply the brake pedal
or move the transmission to neutral (N) you
can override your vehicle s acceleration.

Ready to Drive

Lights after your switch your
vehicle on and it is ready to drive.
E144692
A corresponding message may
display stating ready to drive.

Service Engine Soon

If the service engine soon
indicator light stays on after you
switch on the engine, this
indicates that the On-Board Diagnostics
system (OBD) has detected a malfunction
of the vehicle emissions control system.
Refer to On-Board diagnostics (OBD) in
the Fuel and Refueling chapter for more
information about having your vehicle
serviced. See Emission Control System
(page 142).
If the light is blinking, engine misfire is
occurring which could damage your
catalytic converter. Drive in a moderate
fashion (avoid heavy acceleration and
deceleration) and have your vehicle
serviced immediately.
Note: Under engine misfire conditions,
excessive exhaust temperatures could
damage the catalytic converter or other
vehicle components.
The service engine soon indicator lights
when you first switch on the ignition prior
to engine start to check the bulb and to
indicate whether the vehicle is ready for
Inspection and Maintenance testing.
C-MAX (CCG) Mexico/United States of America/Canada, enUSA, CPE Review
Instrument Cluster
Normally, the service engine soon light will
stay on until you switch on the engine, then
turn itself off if no malfunctions are
present. However, if after 15 seconds the
service engine soon light blinks eight times,
it means that the vehicle is not ready for
Inspection and Maintenance testing. See
Emission Control System (page 142).
Stability Control
E138639
this indicates a malfunction. During a
malfunction, the system will turn off. Have
the system checked by an authorized
dealer immediately. See Using Stability
Control (page 160).

Stability Control Off

or when you switch the ignition off. See
Using Stability Control (page 160).

Stop Safely

shutdown or enter into a limited operating
mode. A message may also display.
Vehicle Plugged in
attempting to start the vehicle.
86
Lights when the system is active.
If it remains on or does not light
when you switch the ignition on,
Lights when you switch the
system off. It will go out when
you switch the system back on
Indicates an electrical
component fault or failure that
E144693
will cause the vehicle to
Lights after you plug in your
vehicle. A corresponding
E144694
message may display after
(If Equipped)