Operation; Remote Control; Switching On/Off; Loading/Ejecting A Cd - Omnitronic CMP-102 User Manual

6. OPERATION

The CMP-102 can either be operated via the buttons on the front panel or via the remote control.
However, the buttons to memorize and play a continuous loop can only be found on the remote control.

6.1 Remote control

1. When actuating a button, always direct the remote control towards the sensor. The must be no obstacles
between remote control and the sensor.
2. If the range of the remote control decreases, the batteries are probably exhausted and must be replaced.

6.2 Switching on/off

1. Prior to switching on, turn all level controls to minimum to prevent switching noise.
2. Switch on the CMP-102 with the power button. The unit will automatically detect if a CD is inserted
(indication LOAD CD). If an audio CD is inserted, the display will shortly indicate the total number of titles
and the total remain time followed by information concerning the first title after the read-in. For MP3 CDs
the total number of folders and titles of the first folder will shortly be displayed.
3. If no CD is inserted "NoDisc" will be displayed.
4. Prior to switching the unit off, always terminate the playback with the button
press the power button to switch off the unit.

6.3 Loading/ejecting a CD

1. Slide in a CD with the lettering upwards so far into the slot until it is retracted automatically. The display
indicates LOAD CD.
2. To eject the CD press the button EJECT ( ). The display will indicat OPEN and the CD will be ejected
and can be removed. Before ejecting the CD always pause or terminate the playback. While playing a
CD, the CD drive is locked against unintentional opening.

6.4 Basic settings

After switching on, the rotary pitch control and the modes continuous play and elapsed title time will be active
as basic settings. These settings can be changed.
1. In the basic setting the rotary pitch control is active (green LED of the button PITCH lights) and the
playback speed can be adjusted variably up to ±24 %. To deactivate the function press the button PITCH
(green LED extinguishes).
2. In the basic setting continuous play all titles of are played one after the other and the unit stops at the
end of the last title. Press the button SGL (LED lights yellow) on the player or the button SGL/CTN on
the remote control to switch to single title play. Then the unit is set to pause at the start of the next title
after playing a title.
3. As a basic setting, the display will show the elapsed time of the current title numerically in minutes,
seconds and frames (1 frame = 1/75 second). With the button TIME the time indication can be switched
over:
• first actuation of the button: remaining title time
• second actuation of the button: total remaining time (only with audio CDs)
• third actuation of the button: return to basic setting
In addition to numerical time indication, the playing time is indicated graphically by the length of the
bargraph for audio CDs. The number of segments of the bargraph will be increased with increased
playing time. The bargraph will begin to flash in its full length 35 seconds before the playing time is
ending.
26/30
or the button . Then
00052162.DOC, Version 1.0