Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for EIC Solutions AAC-140B-4XT
Summary of Contents for EIC Solutions AAC-140B-4XT
- Page 1 EIC SOLUTIONS, INC Thermoelectric Air conditioner installation and operation manual FOR 400 Btu MODEL #’S AAC-140B-4XT AAC-140B-4XT-HC AAC-140B-4XT-XXXXX Cooling Solutions for Mission-Critical Electronics -800-497-4524 EIC SOLUTIONS, INC 215-443-5190...
-
Page 2: Table Of Contents
INSTALLING THE AIR CONDITIONER ............. INSTALL THE DRIP PAN ................APPLY POWER .................... 3. OPERATION THERMOSTAT SET POINTS AND HEATING COOLING UNITS ... MAINTENANCE ..................EIC SOLUTIONS INC. 1825 STOUT DRIVE WARMINSTER, PA 18974 PHONE 1-215-443-5190 or 1-800-497-4524 FAX 215-443-9564 EMAIL info@eicsolutions.com... -
Page 3: General Information
Your EIC Solutions Thermoelectric Air Conditioner operates on this principle so there is no compressor and no expensive, ozone depleting CFC’s. EIC’s air conditioners use Thermoelectric “modules”... -
Page 4: Installation
Horizontally mounted 400 Btu units always require a factory installed drip pan (part # DP-140H) to prevent dripping condensate from damaging electronic equipment. (Fig. 2.2) In either orientation, issues regarding access should be considered and minimum clearances must be maintained as outlined in Section 2.1 of this manual. -800-497-4524 EIC SOLUTIONS, INC 215-443-5190... - Page 5 COLD SIDE HEAT SINK FINS COLD SIDE OF AC (INSIDE OF ENCLOSURE) DRAIN TUBE COLD SIDE FAN HORIZONTAL INSTALLATION OF AAC-140B-4XT, 400 BTU UNIT WITH INTERNALLY MOUNTED DP-140H DRIP PAN AND DRAIN TUBE FIGURE 2.2 -800-497-4524 EIC SOLUTIONS, INC 215-443-5190...
-
Page 6: Preparing The Enclosure
You also received a cut out stencil with your air conditioner. The instructions for installing the air conditioner are printed below. TOOLS AND MATERIALS NEEDED: • AAC-140B-4XT cut out stencil • Center Punch • Tape Measure and pencil • Jigsaw or suitable alternative •... -
Page 7: Install The Drip Pan
2. There is one mounting hole in the drip pan, match this hole with the long mounting screw protruding into the enclosure at the bottom of the AC unit. Push the drip pan onto this screw. -800-497-4524 EIC SOLUTIONS, INC 215-443-5190... -
Page 8: Apply Power
Black or Brown – line White or Blue – line/neutral Green or Green/Yellow – ground A wiring diagram is shown in Fig. 2.4 below. Amperage for a 220 VAC unit is 1.4 amps. Figure 2.4 -800-497-4524 EIC SOLUTIONS, INC 215-443-5190... - Page 9 The cold side fan always runs to circulate air within your enclosure thereby eliminating any “hot spots”. The hot side fan will only run when the air conditioner is cooling – they are “pumping” the heat from the inside of your enclosure to the outside air. -800-497-4524 EIC SOLUTIONS, INC 215-443-5190...
-
Page 10: Operation
3. Your AAC-140B-4XT air conditioner is rated NEMA 4X and is designed to allow for water wash down of the hot side of the unit, which is outside of the enclosure (never the cold side which is inside the enclosure).
Need help?
Do you have a question about the AAC-140B-4XT and is the answer not in the manual?
Questions and answers