INSTALL THE DRAIN LINES ....................APPLY POWER ........................3. OPERATION THERMOSTAT SET POINTS AND HEATING COOLING UNITS ........MAINTENANCE ........................EIC SOLUTIONS INC. EIC SOLUTIONS INC. EIC SOLUTIONS INC. EIC SOLUTIONS INC. 700 VETERANS WAY, SUITE 200 WARMINSTER, PA 18974...
Your EIC Solutions Thermoelectric Air Conditioner operates on this principle so there is no compressor and no expensive, ozone depleting CFC’s. EIC’s air conditioners use Thermoelectric “modules” sandwiched between high performance aluminum heat sinks, high CFM axial fans, and a patented electronic design to “pump”...
(Fig. 2.2) In either orientation, issues regarding access should be considered and minimum clearances must be maintained as outlined in Section 2.1 of this manual. 4 4 4 4 -800-497-4524 EIC SOLUTIONS, INC 215-443-5190...
5. Install the rest of the screws in the flange placing a nylon washer on each fastener and screw them into the holes in the enclosure. Do not tighten them completely. 6. Remove the two starter screws and place a nylon washer on each and reinstall. 7. Tighten all screws. 6 6 6 6 -800-497-4524 EIC SOLUTIONS, INC 215-443-5190...
YOU MUST USE THE FACTORY INSTALLED HORIZONTAL DRIP PAN IF YOU INSTALL THE AIR CONDITIONER HORIZONTALLY (FIG 2.2) ON THE TOP OF YOUR ENCLOSURE. FAILURE TO DO SO MAY ALLOW CONDENSATE TO DRIP IN AN UNCONTROLLED MANNER CAUSING DAMAGE TO YOUR EQUIPMENT. 8 8 8 8 -800-497-4524 EIC SOLUTIONS, INC 215-443-5190...
“hot spots”. The hot side fans will only run when the air conditioner is cooling – they are “pumping” the heat from the inside of your enclosure to the outside air. 9 9 9 9 -800-497-4524 EIC SOLUTIONS, INC 215-443-5190...
NEVER EXPOSE THE COLD SIDE OF ANY AIR CONDITIONER (INSIDE THE ENCLOSURE) TO WATER. If you have any questions about any aspect of your EIC air conditioner, don’t hesitate to call us at the numbers listed below. -800-497-4524 EIC SOLUTIONS, INC 215-443-5190...
Need help?
Do you have a question about the AAC-170 Series and is the answer not in the manual?
Questions and answers