Table of Contents
Advertisement
Folder, Printer, and Share Management
Removing the print server role
To remove the print server role:
1. Click Start > Settings > Control Panel, double-click Administrative Tools, and then
2. Click on Add or Remove a Roll.
3. A wizard will start. Click Next.
4. Select Printer Server from the list of Server Roles and click Next.
5. Select the checkbox Remove the printer role, click Next.
6. The Printer role will be removed, click Finish.
Adding an additional printer
To add additional printers to the NAS device:
1. Select Start > Settings > Printers and Faxes > Add Printer.
2. The add printer wizard will start. Click Next.
3. Select Local Printer and uncheck "automatically detect install my plug and play printers"
Note:
network. The NAS server only supports network attached printers and does not support directly
connected printers via USB or Parallel Port.
4. Select Create a new port, and select Standard TCP/IP Port (recommended).
5. The Add Standard TCP/IP Printer Port Wizard starts. Click Next.
6. Type the name or IP address of the printer. The IP address is usually listed on the printer
7. The wizard attempts to connect to the printer. If the wizard is able to connect, the
8. Select the manufacturer and the type of printer from the presented list, click Next. If the
9. Enter the name of the desired printer to be presented on the NAS device, click Next.
106
double-click Manage Your Server.
click Next.
Local Printer is used to create a TCP/IP port connections to a network enabled printer over the
configuration page. The wizard completes the Port Name field. Click Next.
Completing the Add Standard TCP/IP Printer Port Wizard page appears, and click
Finish. If the wizard is not able to connect, the Additional Port Information Required
page appears.
a. Verify that the IP address or name that was entered is correct.
b. Select Standard to identify the printer network adapter. A list of manufacturers and
models of the network adapters is displayed. Select the appropriate printer from the
Standard list.
c. If the printer network adapter uses nonstandard settings, click Custom and then click
Settings. The Configure Standard TCP/IP Port Monitor page appears. Specify the
settings that are recommended by the manufacturer of the printer network adapter, and
then click OK.
d. Click Next.
printer does not exist in the list, click have disk and load the drivers or select a compatible
driver.
NAS 1500s and 500s Administration Guide
Advertisement
Table of Contents
