Description - Omnitronic E-Series User Manual

The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
The ambient contamination must never exceed level 1 and must not be conducting, only dry.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Never remove the serial barcode from the device as this would make the guarantee void.
Please consider that unauthorized modifications on the speaker system are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, hearing loss etc.

5. DESCRIPTION

5.1 Features
Stereo PA amplifier with integrated limiter
• 2 operating modes can be selected (stereo or bridged) with LED indicators
• Limiter, switchable
• Speaker switch-on delay
• 2 level controls
• Each channel with LED for activated protective circuit (protect) and 7-fold output meter with clip LED
• Complete protection set against short-circuit, overheat, DC voltage, power on/off transients
• Groundlift switch against humming
• Fan cooling
• Speaker outputs via lockable Speaker jacks and pairs of screw terminals
• E-200, E-300, E-600 und E-900: signal inputs via XLR, RCA or 6.3 mm mounting jacks
• Additional Speaker plug for 8-ohm bridge operation
• E-1300: signal inputs via XLR or 6.3 mm mounting jacks
• 8-ohm bridge operation via screw terminals or additional Speaker plug
• Rack installation
23/32 00043864.DOC, Version 1.1