Sub-Zero 700TF(I) Planning Information page 7

Planning Information
Model 700TF(I)
I N T E G R A T I N G C A B I N E T R Y
F R A M E D C A B I N E T R Y
SUB-ZERO
UNIT
CABINET
FRAME
CABINET
1
/ " (3)
8
DOOR
REVEAL
1
Traditional Frame – full overlay.
SUB-ZERO
UNIT
CABINET
FRAME
1
CABINET
1
/ " (3)
8
DOOR
REVEAL
Traditional Frame – standard overlay.
S
SUB-ZERO
UNIT
CABINET
FRAME
1
CABINET
1
/ " (3)
8
DOOR
REVEAL
3
Traditional Frame – / " (10) offset.
8
Dimensions in parentheses are in
millimeters unless otherwise specified.
F R A M E D C A B I N E T R Y A P P L I C A T I O N S
Framed cabinetry applications present you with different
questions to address. The illustrations on this page show
common applications of framed cabinetry. These are not
meant to be the only alternatives, but are suggestions
from designers around the country. Also refer to the full-
scale illustrations at the end of this section for specifics
on door openings.
IMPORTANT NOTE: The depth of each Integrated unit is
24
24" (610) from the front of the unit to its back. You must
(610)
TO WALL
allow for the thickness of the panel you are applying when
planning for the finished rough opening depth if you want
the front panel to be flush with surrounding cabinetry. You
may have to move the unit back into drywall or bring the
cabinets forward to achieve a flush fit. Refer to the
PANEL
illustrations.
27
(686)
Illustrations on the following pages give dimensions for an
Integrated base or tall unit installed within a framed cabi-
2
netry beaded inset application. Review the illustrations,
giving particular attention to the overall panel specifica-
tions. Also refer to the full-scale illustrations at the end of
this section for specifics on door openings.
T
24
(610)
TO WALL
PANEL
27
(686)
2
T
24
(610)
TO WALL
PANEL
2
27
(686)
7