Elation TVL3000WW User Instructions page 5

TVL3000WW/TVL3000CW
System Menu.
The TVL3000WW & TVL3000CW come with an easy
to navigate system menu. This next section will detail the functions of
each command in the system menu. Please read the next section
thoroughly!
To access the main menu press the MENU button. Tap the UP or
DOWN buttons until you reach the function you wish to change. When
you reach the function you wish to change press the ENTER button.
When a function is selected use the UP or DOWN buttons to change
the function settings. Once your changes are made press the ENTER
button, and then press and hold the MENU button for at least three
seconds to confirm and lock the change into the system memory. If
the MENU button is not pressed and held within eight seconds the
fixture will automatically confirm and lock the change into the system
memory. To exit without making any changes press the MENU button.
ADDR -
DMX Address Setting.
1. First set the unit to your desired DMX Channel mode.
2. To set your address, tap either the MENU, UP, or DOWN
buttons until "ADDR" is displayed, press ENTER. "1" will now be
displayed and flashing.
3. Press the UP or DOWN buttons to find your desired address.
When you have found your desired DMX address press ENTER,
and connect your DMX Controller.
DIMM -
Dimmer mode.
1. Press the MENU button until "DIMM" is displayed, press
ENTER.
2. Use the UP and DOWN buttons to adjust the intensity until
you reach your desired intensity.
©Elation Professionals® - www.elationlighting.com - TVL3000WW/TVL3000CW Instruction Manual Page 9
System Menu TVL3000WW/TVL3000CW
BLND -
1. Press the MENU button until "BLND" is displayed, press
ENTER. Either Yes or No will be displayed.
2. To activate Blackout press the UP or DOWN buttons until Yes
is displayed, press ENTER to confim and exit. The fixture will
now be in Blackout mode. To deactivate Blackout mode, select
No and press Enter.
TEST
1. Tap the MENU button until "TEST" is displayed, press ENTER.
2. The fixture will now run a self test program. To stop the self
test press either the MENU or ENTER button.
LED -
turn off after 20 seconds.
1. Press the MENU button until "LED" is displayed, press
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to keep the LED display On at all
times, or "OFF" so that the LED display turns off after 20 sec-
onds.
3. Press ENTER to confirm.
DISP -
1. Press the MENU button until "DISP" is displayed, press
ENTER.
2. Press the UP button to select "ON" to reverse the display, or
"OFF" to reverse it back.
3. Press ENTER to confirm.
©Elation Professionals® - www.elationlighting.com - TVL3000WW/TVL3000CW Instruction Manual Page 10
Blackout or Stand by mode.
- This function will run a self test program.
With this function you can have the LED display
This function will reverse the display 180º.
System Menu