Proficient One Owner's Manual page 9

Pinch Adapter Locks
together so they will slide
through hole in cabinet door
Adapter Bezel
Diagram 11 - Flush Mount Adapter -
Install Adapter
5. NOTE: It is recommended that the
Electronics Module be mounted to an
inside wall of the cabinet. If attached with
adhesive, there is some possibility that if
mounted to the door, in time, the module
could come loose from the action of the
door opening and closing and ultimately
fall off, potentially damaging the IR
Receiver the Electronics Module or both.
Using an appropriate length wood screw (not
included) attach the Electronics Module to an
inside wall of the cabinet. Use a screw that will
secure the module but will not penetrate the
outside wall of the cabinet. Do not overtighten
the screw to avoid damaging the Electronics
Module case. Diagram 13 OR...
Use one of the included adhesive strips to
attach the Electronics Module to the inside of
the cabinet.
6.
Carefully run the plug end of the Receiver
Cable to where the IR Router will be located.
Be careful not to pinch or strain the cable.
If this is your application, when finished, proceed to
section: Typical Connections.
Cabinet Door
11/16" (17.4mm)
Diameter Hole
8" Receiver Cable
INSTALLING THE RECEIVER
Cabinet Door
Leave adequate space between the Adapter Locks
and the A/V components with the cabinet door closed.
Diagram 12 - Flush Mount Adapter -
Adapter Installed
Flush Mount
Adapter Bezel
Use wood screw or
adhesive to attach
Electronics Module to
back of cabinet door or
inside wall of cabinet.
Diagram 13 - Flush Mount
Secure Electronics Module
9
8" Receiver Cable
Cabinet Door
8" Receiver Cable
Electronics
Module
To IR Router
Adapter -
RCVR Jack