Installing The Ir Receiver; Surface Mount - Proficient One Owner's Manual

SURFACE MOUNT

The first, and easiest option, is to mount the IR Receiver on the front frame of a flat panel
TV. This application can also be used to surface mount the IR Receiver to other objects.
1.
Select a location on the TV frame to mount the IR Receiver. Be sure the receiver will
not be blocked by any object to allow 'line-of-sight' to the remote control in normal
use.
2.
With the IR Receiver 8" Receiver Cable directed toward the edge of the TV, using
one of the included adhesive strips, carefully attach the IR Receiver to the TV frame.
Diagram 1
3. Carefully flatten and wrap the 8" Receiver Cable around to the back of the TV. The
Receiver Cable can be secured to the TV with tape or a wire holder if necessary. Do
not block any TV vents.
4.
Using one of the round adhesive strips, carefully attach the Electronics Module to
the rear of the TV. Do not block any TV vents.
5.
Carefully run the plug end of the Receiver Cable into the cabinet with the A/V
components to where the IR Router will be located. Be careful not to pinch or strain
the Receiver Cable. The Receiver Cable can be secured to the back of the TV with
tape or a wire holder. Do not block any TV vents.
If this is your application, when finished, proceed to section: Typical Connections.
Diagram 1 - Surface Mount - Flat Panel TV

INSTALLING THE IR RECEIVER

Front of TV
Attach with
Adhesive
PROFICIENT
ONE
IR Receiver
8" Receiver Cable
5
Attach with
Adhesive
To IR Router
RCVR Jack
PROFICIENT ONE
Electronics Module