Proficient One Owner's Manual page 17

Symptom #4: IR Flashers flash but some (or all) components do not
respond.
Cause
1. Flasher placement is incorrect.
2. Flasher placement is correct but
the signal is overpowering the
unit or there is bleed-through
from other Flashers close by.
IR TROUBLESHOOTING GUIDE
Solution
Reposition the Flasher so that it is di-
rectly over the component's IR eye. Shine
a small flashlight into the front panel
of the component to locate the eye or
consult the component's owner's manual
for the exact location of the IR eye.
Reposition the Flasher so it is not directly
over the IR eye to reduce the amount of
IR signal the IR eye on the component
being controlled 'sees' . If the A/V source
(i.e. cable box, DVR or satellite box) sees
the IR signal twice, the source will not
process it correctly. Place a piece of black
electrical tape over the Flasher to block
reflected IR signals.
17