Proficient One Owner's Manual page 7

Receiver Cable
Pass-Through
Tabletop Adapter
IR Receiver
Lens
Diagram 6 - Tabletop Adapter -
Insert IR Receiver
TABLETOP ADAPTER
The Tabletop Adapter allows mounting the
IR Receiver in an attractive low-profile case
creating an IR Receiver that can be placed on
any shelf or tabletop.
1.
Remove the Tabletop Adapter Base by
rotating it counter-clockwise as shown in
Diagram 8.
2.
Position the Tabletop Adapter top so the
lens is facing down as shown in Diagram 6.
3.
With the 8" Receiver Cable on the IR
Receiver facing up, carefully insert the IR Receiver into the socket on the backside of
the lens as shown in Diagram 6. The receiver should snap into place when properly
inserted.
4.
With the 'bottom notch' of the Electronics Module facing you, carefully slide the
module onto the post in the Electronics Module Socket as shown in Diagram 7.
5.
Carefully wrap the 8" Receiver Cable around the Electronics Module and extend the
plug end of the Receiver Cable out of the Tabletop Adapter case via the Receiver
Cable Pass Through as shown in Diagram 7.
6.
Align the Adapter Base to the Adapter Top with the 'wide gap' aligned at the top
with the IR Receiver as shown in Diagram 7. Tighten the base to the top as shown in
Diagram 8.
If this is your application, when finished, proceed to section: Typical Connections.
Top Inside
8" Receiver Cable
INSTALLING THE RECEIVER
Wide Gap
Base Lock At Top
Base Lock
Tabletop Adapter Base -
Inside
Diagram 7 - Tabletop Adapter -
Insert Electronics Module
Rotate Clockwise
to Tighten
Diagram 8 - Tabletop Adapter -
7
Lens
IR Receiver
Base Locks
Receiver Cable
Pass-Through
Base Lock
Lens
Rotate Counter-clockwise
to Remove
Remove/Tighten Base
Base Lock
Electronics
Module
Socket
Electronics
Module
'Bottom Notch'
To IR Router
RCVR Jack
To IR Router
RCVR Jack