Proficient One Owner's Manual page 8

INSTALLING THE RECEIVER
Diagram 9 - Flush Mount Adapter -
11/16" Hole
FLUSH MOUNT ADAPTER
The Flush Mount Adapter allows mounting the IR Receiver in an equipment cabinet door.
This allows IR controlled audio/video components to be controlled with the cabinet door
closed.
This application requires drilling an 11/16" (17.4mm) hole in the cabinet door as shown in
Diagram 9. It is recommended that the IR Receiver be mounted closer to the hinged side
of the cabinet door so the Electronics Module can be mounted to an inside wall rather
than the door.
1.
Select a location on the cabinet door to mount the Flush Mount Adapter. Be sure to
leave adequate clearance from the back of the cabinet door to the front of the A/V
components to allow room for the Adapter Locks with the door closed. (Diagram
12) Also be sure that once mounted, the IR Receiver will not be blocked by any
object to allow 'line-of-sight' between the remote control and the IR Receiver in
normal use.
2. Drill an 11/16" (17.4mm) diameter hole in the cabinet door. Diagram 9
3.
From the back side of the cabinet door, feed the IR Receiver through the hole in the
cabinet door. Carefully pull the 8" Receiver Cable straight back from the IR Receiver
and with the receiver lens oriented to match the orientation of the adapter (thick
sections 12 and 6 o'clock) push the IR Receiver into the back of the adapter until it
snaps into place. Diagram 10
4.
Pinch the Adapter Locks together and carefully slide the adapter/receiver assembly
through the hole until the adapter bezel is pressed against the front of the cabinet
door. Be sure to align the thick sections of the bezel at 12 and 6 o'clock for best left
to right off-axis performance. (It will look better that way as well.) Diagram 11
Cabinet Door
11/16" (17.4mm)
Diameter Hole
5/8" (15.9mm)
Door Panel
Flush Mount
Adapter Bezel
Diagram 10 - Flush Mount Adapter -
Install IR Receiver
8
Cabinet Door
Push IR Receiver
until it snaps into place
8" Receiver Cable