Titan SF115XP Safety And Operating Manual page 11

spindle lock button and remove the wrench.
4. SWITCH (see fig4)
The On/Off trigger switch is sprung in the OFF
position. The angle grinder is started by pushing
forward the locked off lever and simultaneously
gripping the trigger switch. See fig4. To stop the
angle grinder, release the trigger switch and it will
automatically return to the OFF position.
WARNING!The disc will continue to rotate
for a few seconds after the angle grinder
has been switched off. Always wait until the disc
has stopped completely before putting the angle
grinder down. Do not attempt to operate the
spindle lock button while the disc is still rotating.
5. TO USE GRINDER (see fig5)
Attention: Do not switch the grinder on whilst the
disc is in contact with the workpiece. Allow the
disc to reach full speed before starting to grind.
Hold your angle grinder with one hand on the
main handle and other hand firmly around the
auxiliary handle.
Always position the guard so that as much of the
exposed disc as possible is pointing away from
you.
Be prepared for a stream of sparks when the disc
touches the metal.
For best tool control, material removal and
minimumoverloading,maintainananglebetween
the disc and work surface of approximately 15
30 when grinding and 10
0
Exert light pressure on abrasive discs for efficient
operation. Pushing too hard will cause a drop
in speed and may result in motor overload and
damage.
Use caution when working into corners as
contact with the intersecting surface may cause
the grinder to jump or twist. When grinding is
complete allow the workpiece to cool. Do not
touch the hot surface.
6. OVERLOAD
Overloading will cause damage to the motor of
your angle grinder.This can happen if your angle
grinder is subjected to heavy use for prolonged
periods of time.
Do not in any circumstances, attempt to exert too
much pressure on your angle grinder to speed up
your work.
4 ANGLE GRINDER
-15 When sanding.
0 0
Locked
off lever
Fig 4
Fig 5
-
0
On/off
switch button
15°-30°
SF115XP