Titan SF115XP Safety And Operating Manual page 10

Fig 1
Tighten
Loosen
Fig 2
Dise
Inner
Spindle
flange
Fig 3
OPERATION INSTRUCTIONS
manual carefully.
1. INSTALLING THE AUXILIARY HANDLE
(see fig1)
An auxiliary handle is supplied and can be fixed
into any of the three positions on the gearcase. If
you are right handed fit the handle as shown in
fig1. If you are left handed fit the handle the other
way round. When using a cutting disc, you can
screw the handle into the position on top of the
gearcase.
NOTE: This handle should be used at all times to
maintain complete control of the tool.
2. ADJUSTING WHEEL GUARD (see fig2)
Adjust the guard to protect your hands and direct
grinding debris. Loosen the clamp lever. Position
the guard at the required angle. Then tighten the
clamp lever.
If the guard is still loose when the clamp lever
is tightened, loosen the clamp lever, and screw
down the nut on the guard. Then tighten the
clamp lever again until the guard is secured and
will not move in use.
CAUTION: Be sure that the guard is secure
before starting the angle grinder.
3. FITTING THE DISCS (see fig3)
Place the grinding/cutting disc on top of the inner
flange and over the spindle. Ensure that it is firmly
located on the raised section of the inner flange.
See fig3. Locate the outer flange over the disc,
making sure that the raised side is facing the disc
and is fully located in the centre hole of the disc.
NOTE: When clamping thin section metal
Outer
flange
diamond discs, the outer flange must be reversed
so that the flat/dished side screws against the
disc hub.
Press and hold down the spindle lock button and
tighten the outer flange using the two pin locking
wrench. It may be necessary to turn the spindle to
fully locate the spindle lock button.
When the outer flange washer is tight, release the
WARNING:
Before using your angle
grinder be sure to read the instruction
WARNING: Never use the angle grinder
without the disc guard in place.