Replacing The Controller Module - Rorke Data Galaxy HDX2-2430S-16U4D Installation And Hardware Reference Manual

Step 8. Carefully pull the controller module out of the subsystem chassis

5.2.3 Replacing the Controller Module

If the controller module itself has failed, it must be replaced. To replace a
failed controller module:
Step 1. Remove the controller module from the subsystem (see Section
Step 2. Install the DIMM module and BBU onto the new controller
Step 3. Install the controller module. Make sure the levers at the back of
Step 4. Secure the connection. Once the controller reaches the end and
Step 5. Secure the controller module to the subsystem by fastening the
Replacing Controller Module Components
Figure 5-3: Removing the Controller Module
keeping one hand underneath to support the weight of the module.
5.2.2.) If the BBU and the DIMM module are undamaged, they can
be removed and reinstalled on the new controller module. For
instructions on removing and installing a BBU and a DIMM
module, please see Section 5.3 and Section 5.4.
module; making sure that the modules are securely in place. (See
Section 5.3)
the controller module are down. Align the controller module with
the controller module bay at the rear of the subsystem. Gently slide
the controller module in.
you feel the contact resistance, you can lift up the levers on the
sides. The levers will ensure the back-end connectors are properly
mated. (See Figure 5-4)
Figure 5-4: Lifting the Controller Levers Upward
two (2) screws previously removed to the holes underneath the
eject levers. (See Figure 5-5)
Chapter 5: Subsystem Maintenance
5-5