Table of Contents
Advertisement
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the Battery (see
a.
Service cover (see
b.
Hard drive (see
c.
Optical drive (see
d.
Keyboard (see
e.
Top cover (see
f.
Speakers (see
g.
System board (see
Remove the power connector cable:
1.
Release the display panel cable (1) from the routing channel built into the base enclosure.
2.
Release the power connector cable (2) from the routing channel built into the base enclosure.
3.
Release the power connector (3) from the molding built into the base enclosure.
4.
Remove the power connector cable.
62
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
29), and then remove the following components:
Service cover on page
Hard drive on page
31)
Optical drive on page
Keyboard on page
38)
Top cover on page
41)
Speakers on page
49)
System board on page
30)
37)
52)
Spare part number
746660-001
Advertisement
Table of Contents
