Table of Contents
Advertisement
3.
Remove the Philllips PM2.0×2.0 broad head screw (2) that secures the card reader board to the
top cover.
4.
Remove the card reader board (3) and cable.
Reverse this procedure to install the card reader board.
Power button board
Description
Power button board (includes cable and double-sided adhesive)
Before removing the power button board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the Battery (see
a.
Service cover (see
b.
Hard drive (see
c.
Optical drive (see
d.
Keyboard (see
e.
Top cover (see
Remove the power button board:
48
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
29), and then remove the following components:
Service cover on page
Hard drive on page
31)
Optical drive on page
37)
Keyboard on page
38)
Top cover on page
41)
30)
Spare part number
746646-001
Advertisement
Table of Contents
