Installation Instructions; Unpacking; Location Requirements - KitchenAid KUCP02IR Use And Care Manual

Kitchenaid use & care guide compactor kucp02ir
Hide thumbs Also See for KUCP02IR:
Table of Contents

Advertisement

Installer: Leave Use and Care Guide with the homeowner.
Homeowner: Keep Use and Care Guide for future reference and
for local electrical inspector's use, if required.

Unpacking

WARNING
Excessive Weight Hazard
Use two or more people to move and install
compactor.
Failure to do so can result in back or other injury.
IMPORTANT:
Do not grasp console to move compactor.
Begin in the room where the compactor will be located.
1. Remove compactor from shipping carton. Remove all
protective packaging materials such as tape and shipping
pads. Use a mild detergent and warm water to remove waxy
residue caused by protective shipping material. Dry
thoroughly with a soft cloth. For more information, see
"Cleaning."
2. Be sure the power cord is attached to the cord clip on the
rear of the compactor.
A
4

INSTALLATION INSTRUCTIONS

A. Cord clip
3. Place the 2 corner posts from the carton on the floor near the
compactor. Open the compactor drawer and remove any
shipping materials or other items from the drawer. Do not
remove the compactor bag. Grasp the handle and raise the
front of drawer until it clears the drawer stops. Grasp sides of
drawer and lift drawer out of compactor. Place the drawer on
the 2 corner posts.
4. Place the other 2 corner posts on the floor to the side of the
compactor. Grasp the sides of the compactor cabinet and put
compactor on its side on top of the corner posts. Remove the
shipping base from the bottom of the compactor.
A
A. Leveling legs
B. Shipping base

Location Requirements

Product Dimensions
34 "
(86.7 cm)
(38.1 cm)
B
24"
15"
(61 cm)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents