Leave Use and Care Guide with the homeowner.
Keep Use and Care Guide for future reference and
for local electrical inspector's use, if required.
Excessive Weight Hazard
Use two or more people to move and install
Failure to do so can result in back or other injury.
Do not grasp console to move compactor.
Begin in the room where the compactor will be located.
1. Remove compactor
from shipping carton. Remove all
protective packaging materials such as tape and shipping
pads, Use a mild detergent and warm water to remove waxy
residue caused by protective shipping material. Dry
thoroughly with a soft cloth. For more information, see
2. Be sure the power cord is attached to the cord clip on the
rear of the compactor.
Place the 2 corner posts from the carton on the floor near the
Open the compactor
drawer and remove any
shipping materials or other items from the drawer. Do not
remove the compactor
bag. Grasp the handle and raise the
front of drawer until it clears the drawer stops. Grasp sides of
drawer and lift drawer out of compactor.
Place the drawer on
the 2 corner posts.
Place the other 2 corner posts on the floor to the side of the
compactor. Grasp the sides of the compactor
cabinet and put
on its side on top of the corner posts, Remove the
shipping base from the bottom of the compactor.
A. Leveling legs
B. Shipping base
A. Cord clip