Table of Contents
Advertisement
5. Position the shoulder belt on your chest so
that it is comfortable and not resting on your
neck. The retractor will withdraw any slack in
the belt.
6. To release the belt, push the red button on
the buckle. The belt will automatically retract to
its stowed position. If necessary, slide the latch
plate down the webbing to allow the belt to
retract fully.
WARNING!
A frayed or torn belt could rip apart in a
collision and leave you with no protection.
Inspect the belt system periodically, checking
for cuts, frays, or loose parts. Damaged parts
must be replaced immediately. Do not disas-
semble or modify the system. Seat belt as-
semblies must be replaced after a collision if
they have been damaged (bent retractor, torn
webbing, etc.).
Adjustable Upper Shoulder Belt
Anchorage
In the front seating positions, the shoulder belt
can be adjusted upward or downward to posi-
28
PAGE POSITION: 30
JOB: @ibm2/chry_pdm/CLS_chrysler-intl/GRP_owners/JOB_202720-en-pat-10MK74-126-ENG-AA/DIV_og
tion the belt away from your neck. Push the
anchorage button to release the anchorage,
and move it up or down to the position that fits
you best.
NOTE:
The adjustable upper shoulder belt anchor-
age is equipped with an Easy Up feature.
This feature allows the shoulder belt an-
chorage to be adjusted in the upward posi-
tion without pressing the release button. To
verify the shoulder belt anchorage is
latched, pull downward on the shoulder belt
anchorage until it is locked into position.
Adjustable Anchorage
As a guide, if you are shorter than average you
will prefer a lower position, and if you are taller
than average you will prefer a higher position.
When you release the anchorage, try to move it
down to make sure that it is locked in position.
In the rear seat, move toward the center of the
seat to position the belt away from your neck.
Second Row Center Lap/Shoulder
Belt Operating Instructions
The second row center lap/shoulder belt fea-
tures a three-point seat belt with a mini-latch
and buckle, which allows the shoulder belt to
detach from the lower anchor when the seat is
folded. The mini-buckle and shoulder belt can
then be stored out of the way in the right side
trim panel for added convenience.
1. Remove the mini-latch and regular latch
from its stowed position in the right rear side
trim panel.
pubnum:
Advertisement
Chapters
Table of Contents
