Evic Functions; Engine Oil Change Indicator System - If Equipped - Chrysler Patriot Owner's Manual

• Left/Right Front Door Ajar (one or more, with
a single chime if speed is above 1 mph)
• Left/Right Rear Door Ajar (one or more, with
a single chime if speed is above 1 mph)
• Door (S) Ajar (with a single chime if vehicle is
in motion)
• Gate Ajar (with a single chime)
• Headlamps On
• Key In Ignition
• Check TPM System
• Oil Change Required — If Equipped

EVIC Functions

EVIC Button
116
PAGE POSITION: 118
Press the EVIC button until one of the following
functions are displayed on the EVIC:
• Compass/Temperature/Audio
• Average Fuel Economy
• Distance To Empty (DTE)
• Elapsed Time
• Tire Pressure Monitor (TPM)
• Personal Settings
To Reset The Display
Pressing and holding the EVIC button once will
clear the function currently being displayed.
Reset will only occur if a resettable function is
currently being displayed. To reset all reset-
table functions, press and release the EVIC
button a second time within three seconds of
resetting the currently displayed function (reset
ALL will be displayed during this three-second
window).
JOB: @ibm2/chry_pdm/CLS_chrysler-intl/GRP_owners/JOB_202720-en-pat-10MK74-126-ENG-AA/DIV_og
Engine Oil Change Indicator
System — If Equipped
Oil Change Required
Your vehicle is equipped with an engine oil
change indicator system. The "Oil Change Re-
quired" message will flash in the EVIC display
for approximately five seconds after a single
chime has sounded, to indicate the next sched-
uled oil change interval. The engine oil change
indicator system is duty-cycle based, which
means the engine oil change interval may
fluctuate dependent upon your personal driv-
ing style.
Unless reset, this message will continue to
display each time you turn the ignition switch to
the ON/RUN position. To turn off the message
temporarily, press and release the Trip Odom-
eter button on the instrument cluster. To reset
the oil change indicator system (after perform-
ing the scheduled maintenance) refer to the
following procedure.
1. Turn the ignition switch to the ON position.
Do not start the engine.
2. Fully depress the accelerator pedal, slowly,
three times within 10 seconds.
pubnum: