Changing The Menu Language - Sony KL-W9000A Service Manual

Step 3: Setting up
the remote
control
Inserting batteries
Insert two size AA (R6) batteries (supplied) by
matching the + and – on the battery to the diagram
inside the battery compartment.
Notes
• If the remote control does not operate properly, the batteries
may be worn out. When replacing batteries, replace both of
them with new ones.
• Do not mix old batteries with new ones or mix different types
of batteries together.
• If the electrolyte inside the battery should leak, wipe the
contaminated area of the battery compartment with a cloth and
replace the old batteries with new ones. To prevent the
electrolyte from leaking, remove the batteries when you don't
plan to use the remote control for a long period of time.
• Do not handle the remote control roughly. Do not drop it, step
on it, or let it get wet.
• Do not place the remote control in direct sunlight, near a
heater, or where the humidity is high.
12 -US Getting Started
Changing the menu
language
CENTER/ MENU
SIZE
ENTER
VOL
If you prefer Spanish or French to English, you can
change the menu language.
1
Press MENU.
MENU
2
Press V or v to select OPTION, and press
ENTER.
ENTER
3
Press V or v to select LANGUAGE, and press
ENTER.
ENTER
N
OPTION
AUTO SHUT OFF:OFF
LANGUAGE: ENGLISH
DOT PHASE: 16
4
Press V, v, B or b to select your favorite
language, "ENGLISH," "FRANCAIS (French)"
or "ESPANOL (Spanish)."
5
Press MENU to return to the original
screen.
Notes
• You can operate the menu using the buttons on the monitor.
The VOLUME + button functions the same as V and b, and
VOLUME – as v and B.
• You cannot use the AUTO SHUT OFF function for the input
from VIDEO 1 IN, VIDEO 2 IN, VIDEO 3 IN and DVD IN. (See
page 24.)
Operations
Projecting the
picture
LAMP STANDBY
Power switch
(green)
VOLUME
MENU
ENTER
INPUT SELECT
POWER
MUTING
DISPLAY
VIDEO RGB WIDE
CENTER/
MENU
SIZE
ENTER
VOL
1
If the STANDBY indicator on the front of
the monitor is lit in orange, press POWER
on the remote control to turn on the
power.
POWER
Press the power switch (green) on the monitor if
the STANDBY indicator is not lit.
The green u (power) indicator flashes, then lights
up.
2
Turn on the power of the connected
equipment.
3
Press RGB or VIDEO to select the input you
want to watch.
The selected input indication is displayed on the
screen.
To watch a computer picture input from the
RGB IN connector
Each time you press RGB, the display changes as
follows:
RGB 1 ˜ RGB 2
RGB
To watch a video picture input from the
VIDEO IN jacks
Each time your press VIDEO, the display changes
as follows:
VIDEO 1 n VIDEO 2 n VIDEO 3 n DVD
VIDEO
You can also select the input by pressing INPUT
SELECT on the monitor.
Each time you press INPUT SELECT, the display
changes as follows:
RGB 1 n RGB 2 n VIDEO 1 n VIDEO 2 n VIDEO 3 n DVD
INPUT SELECT
The input signal indication will automatically
disappear.
4
Press VOL +/– (VOLUME +/–) to adjust the
volume.
Remote control Monitor
VOL
VOLUME
+
–
(continued)
13
Operations -US
US