Table of Contents
Advertisement
KL-W7000A/W9000A
RM-Y980
BASIC ADJUSTMENT IN SERVICE MODE
1. To enter SERVICE mode
1)
Turn the POWER switch on the TV set "ON", then
make it in standby status with the remote commander.
2)
Operate the remote commander as follows:
Screen display
CH "5"
Volume "+" side
POWER "ON" (remote commander)
2. To read the memory
1)
Enter SERVICE mode.
Press 0 n ENTER buttons on the remote com-
2)
mander, and the adjusted values and set values of all
items written in the memory are read out.
Note: If the memory IC was replaced, do not read the memory
before writing standard values.
3. Adjustment of screen
1)
Select the item No. to be adjusted using 1 and 4 buttons
on the remote commander.
2)
Adjust with 3 and 6 buttons so as to satisfy the picture
quality and the set values.
4. To write data in the memory
•
After adjustment, press "MUTING" ENTER buttons
to write data in the memory.
Press ENTER button while green "WRITE" is dis-
played on the screen (within about 3 seconds).
Color of WRITE characters on screen
When MUTING button ON ... .............. Green
When ENTER button ON ..................... Red
5. To release SERVICE mode
•
Turn off the POWER switch on TV set and again turn it
on. As a result, the SERVICE mode display is cleared
and normal TV mode is resumed.
•
Or, turn off the POWER switch from the remote com-
mander and again turn on the POWER switch on the re-
mote commander in the standby status. As a result, the
SERVICE mode display is cleared and normal TV mode
is resumed.
6.
To write +standard values+
1)
Enter SERVICE mode.
2)
Press 8 button, and green +INIT+ is displayed at the
upper right of screen. Successively, press ENTER but-
ton while this characters are displayed (within about 3
seconds). Green characters change to red +INIT+, then
the screen becomes blank, and after about 5 seconds, the
RGB 1 is selected and the operation stops. At this time,
green +G+ is displayed. When +standard values+ writ-
ing is executed, the standard data in the microprocessor
on the selected channel are written in the memory. Thus,
the initialization is made.
Note: Writing of +standard values+ must be executed
initially, only if the memory IC 2008 and 2009
were replaced.
– 26 –
Advertisement
Table of Contents
