KitchenAid Overlay Overlay Model Refrigerator Use And Care Manual page 8

3. Attach the top trim piece to the door frame using the two
screws set aside earlier.
A. Overlay panel assembly
B. Door frame
Reinstall the Gasket
1. Starting at the corners and working toward the center of each
side of the door, push the door gasket back into place.
2. Be sure the door gasket is fully installed on all four sides of
the door.
Install the Door
IMPORTANT: To ensure proper operation, the pivot posts must
be clean; and the closers must be clean and greased with
petroleum jelly.
1. Use two #8—32 x " flat-head screws to attach the top hinge
to the refrigerator.
2. Insert the pivot post into the top hinge as shown.
A. Top hinge
B. Screws
3. Use three #8—32 x " flat-head screws to attach the bottom
hinge to the refrigerator.
4. Insert the pivot post into the bottom hinge.
5. Clean thoroughly and apply petroleum jelly to the mating
surfaces of the closers. Install the door closer–bottom and
door closer–top.
IMPORTANT:
Be sure to properly align the door closer–bottom bosses
with the holes in the bottom hinge.
8
A
B
A
B
Be sure to properly align the door closer–top bosses with
the holes in the hinge plate.
A
B
C
D
E
A. Door frame
B. Pivot plate
C. Door closer–top
D. Door closer–bottom
6. Position the door frame onto the door closer assembly on the
bottom hinge. Using a
securely.
7. Position the door frame and install the pivot post on the top
hinge. Using a " Allen wrench, secure the pivot post.
A. Pivot post
B. Top hinge
C. #8–32 x " flat-head screws
8. Adjust the door frame as needed for proper closure. See
"Door Closing."
F
G
H
E. Pivot post
F. #8—32 x " flat-head screws
G. Bottom hinge
H. Bosses
" Allen wrench, tighten pivot post
A
B
C
D
D. Top pivot plate
E. Door frame