Printing Received Faxes; Receiving Faxes - Brother MFC-235C User Manual

Printing Received Faxes

Difficulty
Condensed print and white streaks
across the page or the top and
bottom of sentences are cut off.
Vertical black lines when receiving. The sender's scanner may be dirty. Ask the sender to make a copy to see if the
Received colour fax prints only in
black and white.
Left and Right margins are cut off or
a single page is printed on two
pages.
Telephone Line or Connections
Difficulty
Dialling does not work. (No dial
tone)
The machine does not answer
when called.

Receiving Faxes

Difficulty
Cannot receive a fax
Sending Faxes
Difficulty
Cannot send a fax
Downloaded from ManualsPrinter.com Manuals
Suggestions
You probably had a bad connection, with static or interference on the telephone
line. Ask the other party to send the fax again.
problem is with the sending machine. Try receiving from another fax machine.
Replace the colour ink cartridges that are empty or nearly empty, and then ask the
other person to send the colour fax again. (See Replacing the ink
cartridges on page 96.)
Turn on Auto Reduction. (See Printing a reduced incoming fax on page 33.)
Suggestions
Check that the machine is plugged in and switched on.
Check the line cord connection.
Change the Tone/Pulse setting. (See Quick Setup Guide.)
Lift the external telephone's handset, (or the machine's handset or cordless
handset if available), and then dial the number to send a manual fax. Wait to hear
fax receiving tones before pressing Mono Start or Colour Start.
Make sure the machine is in the correct receiving mode for your setup. (See
Receive modes on page 30.) Check for a dial tone. If possible, call your machine
to hear it answer. If there is still no answer, check the telephone line cord
connection. If there is no ringing when you call your machine, ask your telephone
company to check the line.
Suggestions
Make sure the machine is in the correct receiving mode for your setup. (See
Receive modes on page 30.)
If you often have interference on the telephone line, try changing the menu setting
of Compatibility to Basic. (See Telephone line interference on page 96.)
If you connect your machine to PBX or ISDN, set the menu setting of Telephone
Line Type to your telephone type. (See Setting the telephone Line
Type on page 36.)
Suggestions
Make sure that the Fax
mode on page 24.)
Ask the other party to check that the receiving machine has paper.
Print the Transmission Verification Report and check for an error. (See
Reports on page 48.)
Troubleshooting and Routine Maintenance
key is illuminated. (See Entering Fax
B
85