Checking For Gas Leaks - Weber Spirit E210 ORIGINAL Owner's Manual

m DANGER
Do not use an open flame to check for
gas leaks. Be sure there are no sparks or
open flames in the area while you check
for leaks. Sparks or open flames will
result in a fire or explosion, which can
cause serious bodily injury or death and
damage to property.
m WARNING: The gas connections of
your gas grill have been factory-tested.
We do, however, recommend that you
leak-check all gas connections before
operating your gas grill.
m WARNING: Perform these leak checks
even if your grill was dealer- or store-
assembled.
m WARNING: You should check for gas
leaks every time you disconnect and
reconnect a gas fitting.
NOTE: All factory-made connections have been
thoroughly checked for gas leaks and the burners have
been flame-tested. As a safety precaution, however,
you should check all fittings for leaks before using your
Weber® gas grill. Shipping and handling may loosen or
damage a gas fitting.

CHECKING FOR GAS LEAKS

You will need: A spray bottle or brush or rag and a soap-
and-water solution. (You can make your own soap-and-
water solution by mixing 20% liquid soap with 80% water;
or, you can purchase solution in the plumbing section of
any hardware store.)
A) Turn gas supply on at source.
m WARNING: Do not ignite burners when
leak-checking
Identify your regulator type. Follow the instructions for
that regulator.
Turn Valve
Turn cylinder valve anti-clockwise (1) (2) (3).
Move Lever
Move regulator lever to the on position (4) (5) (6).
PREPARING TO USE YOUR GRILL
1
2
3
5
4
6
17
WWW.WEBER.COM
®