Accessories - PTI Falcon Installation And Operation Manual

If you have purchased the optional computer
interface for the PTI Falcon, you will have a
computer interface cable similar to the one
pictured in Figure Seven. The PTI Falcon
end of the cable will have a nine pin female
connector and will plug into the nine pin
serial port connector on the back of the PTI
Falcon base unit. The other end of the cable
will have either a nine pin female connector
or a twenty five pin female connector,
depending on which was ordered. This end
will plug into the serial port on your computer
Figure Seven
or modem. This cable is not reversible, so
the PTI Falcon end of the cable will be
labeled appropriately.

Accessories

Figure Eight illustrates the PTI gooseneck
stand. This stand is designed to mate with
the PTI remote keypad when it is used in a
drive up application. The keypad mounting
plate contains a center wiring hole which
allows the wire to be fed up through the
stand from underground conduit and three
mounting holes which match the keypad
backplate mounting holes. The mounting
holes are tapped for an 8-32 machine
screw.
The bottom plate of the gooseneck stand
contains a center conduit hole and four
mounting holes arranged on four inch
centers. There is a cover plate which
slides down over the bottom plate after
mounting to hide the mounting plate bolts.
It is highly recommended that the
gooseneck stand be electrically grounded
to minimize the impact of lightning and
static atmospheric charge on the keypad.
Figure Eight
6