Installing Kitchen Front S - Norcool Corner fridge User Manual

4. Fitting furniture fronts (see figures 5, 6 and 7)
1. Hinges. Remove clear plastic film from outer side of fridge door. Remember to check right or left
hinge side. Remove screws in countersunk holes on cold room door. Position correct hinge in
recess and screw securely.
2. Securing furniture front. Lay front(s) on a level surface. Check up/down for fronts and handle
position. Position fridge door correctly on furniture door(s). If in doubt about positioning, fit fridge
door to cabinet and check correct positioning in relation to cornice seal and side plates. Mark
the position of the holes on the wooden panel(s) as required by pushing a long awl through the
plastic bushings and the cabinet's external plastic door panel and into the wooden panel. Then
remove the cabinet door. First, drill the holes in the cabinet's external plastic door panel with
a drill bit, 4.5mm in diameter. Secondly, drill not more than 5mm into the marked positions on
the wooden door panel(s) with a drill bit, 2,5mm in diameter. Lay fridge door on furniture front.
Screw front firmly ( into place with enclosed screws (4x45mm). Do not over-tighten screw to
avoid damaging their hold. Push the plastic hoods onto the screws to hide them.
Fig 7
1. Outer edge fridge door
2. Furniture panel
3. Screw
4. Plastic hoods.
3. Cabinet door. Remove hinge retaining screws in floor and ceiling on side selected for hinges
using Allen key supplied. Open hinges fitted on fridge door. Hold door open, while inserting
hinge screws through holes in hinges. Finger tighten (do not tighten fully) screws in floor and
ceiling – see fig. 5. NOTE: If working alone, place a support under fridge door at correct
height for hinges. Allow door to rest on this while screwing hinges into place.
4. Adjustment and sealing. Door can be adjusted sideways to correct position and then securely
screwed. To check seal, enter cabinet (preferably after corner fridge has been running a while),
close door and check for light around seals.
7