Integrating Corner Fridge Into 2.10 Kitchen S - Norcool Corner fridge User Manual

Corner fridge
4. Cabinet door. Remove hinge retaining screws in floor and ceiling on side selected for hinges
using Allen key supplied. Open hinges fitted on fridge door. Hold door open, while inserting hinge
screws through holes in hinges. Finger tighten (do not tighten fully yet) in floor and ceiling.
NOTE: If working alone, place a support under fridge door at correct height for hinges. Allow
door to rest on this while screwing hinges into place.
5. The magnetic seal can be compressed after being packed and transported. It will return to
original shape once unpacked. Door can be adjusted using adjustment plate supplied it seal is
compressed - see fig. 6B. If magnetic seal presses too hard on door seal or is twisted, open door
90° and loosen hinge screws to floor/ceiling move adjustment plate inwards between hinge and
ceiling/floor and screw securely. See fig. 6A.
6. Adjustment and sealing. Door can be adjusted sideways to correct position and then securely
screwed. To check seal, enter cabinet (preferably after corner fridge has been running a while),
close door and check for light around seals.
Fig 5
Fitting door
3. Integration of corner fridge in 2.10m (see fig 8)
Adjust and level cabinet floor height in accordance with plinth height of your kitchen. Depth of
cover sides and/or worktop will determine distance from room corners. Corner fridge may need to
be pulled forward, as worktop should not be deeper than cover side. This will avoid the door hitting
the worktop. The ideal combination is cover sides of 600mm and door plate 595mm. Pull corner
10mm forward to reduce white line around door as much as possible.
NOTE: Avoid screwing kitchen front too tightly. 1 spacer block is supplied for each side wall.
Do not remove these, as they ensure air circulation and prevent condensation on walls in the
room.
6
Fig 6
Hinges out/in