WI1502A 9/06
DEALER PROGRAM MODE OVERVIEW
EASY MENU DRIVEN
PROGRAM MODE
#of Zns in Area1*
EZ Zone Doubling Enabled?*
Fire Zones*
2-Wire Fire Zns*
Report All ZonesTo Central?*
Exit/Entry Zones*
Interior Zones*
24 Hour Zones*
Chime Zones*
Chime 2 Zones*
Exit/Entry 2 Zones*
50mS Loop Zones*
Aux Output Zones*
Sensor Watch Zns*
KP Sndr Alrm Zns*
Auto Byp REnt Zn
Enable No EOLR Zones*
Enable Telco Line Test?*
Enable Burg Out Chirp?*
Enable CP01 Programming?*
# Area 1 Keypads
Prog a Freedom KP?
Enter Freedom KeyPad #
Enter KeyPad PIR Zone #
Enter Door1 Zone #
Enter Door2 Zone #
Chime 1 Zone #
Chime 2 Zone #
Aux2 Zone #
Add Another Freedom Touch-
pad?
Central Phone #
Central Station Account #
See WI for Info Rcvr Format
Enter user code
ZN#
XMIT#+CS P
KF A XMIT#+CS OP
01 (ZONE DESCRIPTIONS)
Enter Date
Enter Time
Dealer Code
Test Timer
L
NAPCO Security Systems
Dealer Program Mode comprises two operational states:
EASY MENU DRIVEN PROGRAM MODE
•
(or "Cold Started" panels, see address 2286), this mode allows the dealer to customize
the factory panel program to best suit the installation. The Easy Menu-Driven Pro-
gram Mode is a menu-driven utility that prompts the installer to configure the system.
Press
at any time to exit, thus entering Direct Address Program Mode, detailed
C
below.
DIRECT ADDRESS PROGRAM MODE
•
essary, can be made in the Direct Address Program Mode. In this mode, the pro-
gramming address is accessed directly and re-configured by the installer. For more in-
formation, see "DEALER PROGRAM - PRELIMINARY INFORMATION" on page 5.
TYPICAL USER: Dealers / Installers only.
TYPICAL INTERFACE: An F-64PROG programmer.
HOW TO ENTER: Press the factory-installed default Dealer Code:
456789R
"ACTIVATE PROGRAM Y/N" appears on LCD screen. Press STAY ("YES") to enter
the Easy Menu-Driven Program Mode. See Programming Instructions (WI1502)
for additional information regarding the Easy Menu Driven Program Mode.
To exit, press
C
once again to exit Dealer Program Mode.
TO EXIT PRESS
C
AT ANY TIME
DIRECT
ADDRESS
PROGRAM
MODE
(see WI1502 for
more information
TO EXIT PRESS
.
C
AT ANY TIME
*
Initial Configuration Only (new or memory cleared panel);
suppressed thereafter.
programmed panel starts at "# AREA 1 KEYPADS".
- Used with new "out of the box" panels
Additional programming changes, if nec-
-
. Press AWAY ("NO") until
to enter Direct Address Program Mode and press
Scroll Down
Scroll Up
Exit
For the F-64PROG Programmer
Normal entry mode for previously
Freedom F-64 Programming Instructions
Page 39
C
Yes
No