Important Product Information; Licensing Information; Wiring Diagram - Shure ULXS4 User Manual

Certifications
This Class B digital apparatus complies with Canadian ICES-003. Cet
appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
This product meets the Essential Requirements of all relevant European
directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from: www.shure.
com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: EMEAsupport@shure.de
ULX1, ULX2
Certified under FCC Part 74.
Certified by IC in Canada under RSS-123 and RSS-102.
FCC ID: DD4ULX1, DD4ULX2, DD4ULX1G3, DD4ULX2G3. IC:
616A-ULX1, 616A-ULX2.
ULXS4, ULXP4
Approved under the Declaration of Conformity (DoC) provision of FCC
Part 15.
Certified in Canada by IC to RSS-123.

Wiring Diagram

CONDENSER MICROPHONE
4-PIN MINI CONNECTOR
INSTRUMENT CABLE
AUDIO
TIP
SLEEVE
SHIELD

Important Product Information

LICENSING INFORMATION

Licensing: A ministerial license to operate this equipment may be re-
quired in certain areas. Consult your national authority for possible
requirements. Changes or modifications not expressly approved by
Shure Incorporated could void your authority to operate the equipment.
Licensing of Shure wireless microphone equipment is the user's respon-
sibility, and licensability depends on the user's classification and applica-
tion, and on the selected frequency. Shure strongly urges the user to
contact the appropriate telecommunications authority concerning proper
licensing, and before choosing and ordering frequencies.
Information to the user
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note:
EMC conformance testing is based on the use of supplied and recommended cable
types. The use of other cable types may degrade EMC performance.
Please follow your regional recycling scheme for batteries, packaging,
and electronic waste.
WARNING:
defects or other reproductive harm.
Australia Warning for Wireless
This device operates under an ACMA class licence and must comply
with all the conditions of that licence including operating frequencies.
Before 31 December 2014, this device will comply if it is operated in the
520-820 MHz frequency band. WARNING: After 31 December 2014, in
order to comply, this device must not be operated in the 694-820 MHz
band.
BODYPACK TRANSMITTER
AUDIO
GROUND
This product contains a chemical known to the State of California to cause cancer and birth
9