Toshiba e-STUDIO 520 Printing Manual page 269

- Saddle Stitch Finisher — Select this when the Saddle Stitch Finisher is installed.
6) Hole Punch Unit
This sets whether or not the optional hole punch unit is installed.
- None — Select this when a hole punch unit is not installed.
- 2 Holes — Select this when a 2 hole punch unit is installed.
- 2/3 Holes — Select this when a 2/3 hole punch unit is installed.
- 4 Holes (F) — Select this when a 4 hole (F) punch unit is installed.
- 4 Holes (S) — Select this when a 4 hole (S) punch unit is installed.
7) Memory
Select the size of memory installed.
8) Enable SNMP Communication
Check this to enable obtaining the configuration information from this equipment.
If you disable SNMP Communication, TopAccessDocMon notification also will be disabled.
Update Automatically/Manual
Select whether or not to update the configuration information every time the printer driver is
opened. This is available only when "Enable SNMP Communication" is checked.
If the connection to the equipment has not been configured correctly, the message "The
address of your printer could not be located. Would you like to find it?" will be displayed
when the Configuration tab is displayed. If it is displayed, click [Yes] and search for the
equipment using the TopAccessDocMon Local Discovery dialog box. After searching the
equipment, SNMP communication will be enabled. For the instructions on how to search the
equipment, refer to the instructions of TopAccessDocMon.
P.372 "Searching for a Printer"
[Update Now]
Click this to obtain the configuration information from this equipment immediately. This is
available only when "Enable SNMP Communication" is checked.
If the connection to the equipment has not been configured correctly, the message "The
address of your printer could not be located. Would you like to find it?" will be displayed
when you click [Update Now]. If it is displayed, click [Yes] and search for the equipment
using the TopAccessDocMon Local Discovery dialog box. After searching the equipment,
SNMP communication will be enabled. For the instructions on how to search the equipment,
refer to the instructions of TopAccessDocMon.
P.372 "Searching for a Printer"
9) [Drawer Settings]
Click this to set the paper size and paper type of each drawer. The Drawer Settings dialog
box appears by clicking this.
Setting Up Print Options 269