Webasto Telestart T91 Installation Instructions Manual page 10

In conjunction with push-
button
Receiver
ESVT adapter
Digital timer
connector
Pushbutton
Switch
Pinning in cables on ESVT adapter: see
- Appendice 2 for analogue control
- Appendice 4 for W-bus control
- Connect ESVT adapter to 4-pin con-
nector of digital timer
- Connect ESVT adapter to Telestart re-
ceiver
- Connect ESVT adapter to temperature
sensor (only with Telestart T100 HTM)
- Drill hole (16 mm dia.) in location
agreed upon with customer.
- Install pushbutton switch
Note:
When inserting the contacts into the recep-
tacle housing of the pushbutton switch, en-
sure that the colour coding matches that of
the ESVT adapter.
Temperature
sensor
(only with
- Insert contacts into receptacle housing
T100 HTM)
of the pushbutton switch
- Connect the ESVT adapter to the con-
nector on the pushbutton switch.
Caution:
The default setting of the signal input must
be changed from digital timer to pushbutton
switch. See page 16.
Telestart T91 / T100 HTM
Telestart T80 with digital
timer installed
- Remove Telestart T80 receiver
- Install Telestart T91/T100 HTM receiver
as described in installation instructions
Note:
The bracket of the T80 can be used to install
the T91/T100 HTM receiver.
- Remove Y-adapter and replace
with ESVT adapter
Pinning in cables on ESVT adapter: see
- Appendice 1 for analogue control
- Appendice 3 for W-bus control
21