Raymarine CP450C Installation Instructions Manual page 23

Transducer pair connections
Transducer Pair
Frequencies Cable Channel A
Low & High Low frequency
transducer
Low & Medium Low frequency
transducer
Medium & High Medium frequency
transducer
Note: When fitting transducer pairs ensure that channel A and
channel B of the transducer cable are connected to the relevant
transducer as shown in the table above.
Traditional transducer connection
3
Cables and connections
Cable Channel B
High frequency
transducer
Medium frequency
transducer
High frequency
transducer
1
2
Item
1
2
3
Warning: Transducer cables
Do not remove the transducer cable whilst the product
is powered on, doing so can cause sparks. If the
transducer cable is accidently removed whilst the
product is powered on, switch the product's power off,
replace the cable and then switch the power back on.
Caution: Do not cut transducer cables
• Cutting the transducer cable severely reduces sonar
performance. If the cable is cut, it must be replaced,
it cannot be repaired.
• Cutting the transducer cable will void the warranty
and invalidate the European CE mark.
Transducer adaptor cables
Below is a list of transducer adaptor cables which may be required:
Description
Transducer 3m extension cable
Transducer 5m extension cable
Legacy Transducer adapter cable
Combined dual broadband transducer
D12232-1
cable
Description
CP450C
Legacy Adaptor cable
Traditional transducer
Part number
A102148
A102150
A102147
A102146
23