Table of Contents
Advertisement
INSTALLATION
Continued
INSTALLING GAS LOG HEATER
INTO STOVE
1. Remove log and gas log heater from carton.
Note: Do not pick up gas log heater by the
burner itself. This could damage heater. Al-
ways handle the gas log heater by the heater
base only.
2. Remove all protective packaging applied to
log and gas log heater for shipment.
3. Check all items for any shipping damage. If
damaged, promptly inform dealer where you
bought heater.
4. If not already removed, remove back panel
from assembled stove body (see Figure 5,
page 9). Use an adjustable wrench or a 10 mm
socket. Remove six (6) bolts and washers. Keep
bolts and washers to reattach back panel later.
5. Set gas log heater inside stove (see Figure
13). Make sure control knob extensions pass
through bottom front opening.
6. Align outside holes on heater base with four
(4) mounting holes on the stove bottom (see
Figure 13).
7. Fasten heater base to stove bottom with #10-24
x .50 bolts and hex nuts provided with gas log
heater (see Figure 14). Attachment hardware
is factory packed inside plastic bag with
installation manual and owner's registration
card. Push bolt through heater base mounting
hole and through stove bottom. Connect hex
nut to bolt on underside of stove bottom. The
bolt hex head is for a 5/16" socket and the hex
nuts are for a 3/8" socket. If sockets are not
available, use adjustable wrenches.
Bottom
Front
Opening
Bolt
Figure 13 - Placing Heater Base In Stove
Cavity (Appearance May Vary Depending
on Model)
115580-01B
Burner
Heater
Stove
Base
Bottom
www.desatech.com
8. Set one-piece log on heater base as shown in
Figure 15. Make sure middle section at bot-
tom of log is seated into "U" shaped cutout in
center of heater base. Log will fit securely on
base. IMPORTANT: Make sure log does not
cover any burner ports and does not touch the
stove cavity (see Figure 16).
9. Fasten back panel to stove with six (6) M6
x 1.20 mm bolts and washers. Make sure
product identification label is located on the
outside lower left-hand corner.
10. Place freestanding stove in desired position
in room. Be sure to maintain clearances to
combustibles as outlined on page 8.
Bolt
Hex Nut
Figure 14 - Fastening Heater Base to
Stove Drop Bottom
Heater
Base
Figure 15 - Installing One-Piece Stove
Log Set
Burner Porting Areas (double
One-Piece
slotted rectangular openings)
Log Set
Safety Pilot Location
Figure 16 - Top View of One-Piece Log
Set on Gas Log Heater
Heater
Base
Stove Bottom
One-
Piece
Log Set
Middle
Section at
Bottom of
Log Set
Burner
"U" Shaped Cutout
in Chassis
11
Advertisement
Table of Contents
