Table of Contents
Advertisement
INSTALLATION
Continued
9. Fasten stove bottom to stove with four (4)
M6 x 1 - 25 mm bolts. Use a flat washer and
lock washer with each bolt. Tighten bolts into
threaded holes on stove body (see Figure 10
and Figure 8 on page 9). Use an adjustable
wrench or a 10 mm socket.
10. Attach stove door by inserting step bolt
through door hinge pivot holes and into
threaded hole in stove body (see Figure 11).
Use an adjustable wrench or a 12 mm socket
to fasten step bolt. Tighten step bolt until snug.
Make sure door moves freely.
11. Install door catch bolt (M8 x 1.25-55 mm with
two M8 hex nuts) into threaded hole on stove
body (see Figure 8, page 9). Use an adjustable
wrench or a 12 mm socket. The catch bolt has
two hex nuts attached to it (see Figure 12). The
top nut is a bolt stop and the bottom nut is for
door leveling adjustment.
12. Check general catch bolt alignment with door
claw. Make final adjustment and door leveling
after stove is in normal standing position.
13. Carefully lift stove back up on its four at-
tached legs.
Bolt
Leg
Figure 9 - Attaching Stove Legs
Washers
Bolt
Stove
Bottom
Figure 10 - Attaching Stove Bottom
10
14. If available, install gas log heater inside stove
15. Fasten back panel to stove with six (6) M6 x 1
Door
Hinge
Step
Bolt
Door
Bottom Of
Stove Unit
Bottom Of
Stove Unit
www.desatech.com
cavity before installing the back panel (see In-
stalling Gas Log Heater Into Stove, page 11).
- 20 mm bolts and washers. Make sure product
identification label is located on the outside in
lower left-hand corner.
Stove Door
Threaded
Hole
Bolt
Shoulder
Figure 11 - Attaching Stove Door
(Appearance May Vary Depending on
Model)
Door Claw
Figure 12 - Catch Bolt and Door Claw
Orientation
Bolt
Shoulder
Door
Hinge
Step
Bolt
Stove Bottom
Bolt Stop
Adjusting
Nut
Catch Bolt
115580-01B
Advertisement
Table of Contents
