Satellite Dish (Optional) - SAFARI Trek 2002 Owner's Manual

NOTE: If you are using the cable hookup, you must leave the antenna boost switch
This switch also controls whether the system is sending signals to the VCR from the
antenna or a cable connection. When the switch is on, the antenna is being selected. A
shore cable is in use when the switch is off.
The output of the booster switch is wired to the input of the VCR, then from the output of
the VCR to the TV splitter, which supplies the signal. This system allows you to view
from antenna, cable, or VCR.
NOTE: Turn off the antenna boost switch when not in use. It will continue to draw

Satellite Dish (Optional)

Your coach may be equipped with a Sony Digital Satellite Receiver and Datron Mobile
Satellite Television System. Together, these components allow you to access up to 200 dif-
ferent video and audio channels.
The receiver and satellite antenna control units are located in the overhead cabinet in front
of the passenger seat. The signal from the receiver is sent to the VCR and from the VCR
to the television for video and the stereo receiver for audio. No adjustments need to be
made to the VCR to view programs. The system is preset and the television should be
tuned to channel three as with normal VCR use.
To maximize your reception, park in a location that has an unobstructed view of the south-
ern sky. Level your coach before "peaking" (locating the strongest signal from the satel-
lite) your receiver. This will expedite the process and you will not have to re-peak the
receiver after leveling.
For details on how to operate your satellite system and receiver, refer to the Sony and
Datron operating guides.
NOTE: Before you can use the Sony Digital Satellite Receiver, you must first activate
Trek Owner's Manual
4 ~ 58
in the OFF position. Remember to lower the TV antenna before driving.
power from the batteries even when the television is off.
your programming service. You will need to remove the access card from the
backside of the receiver. You should also write down the model and serial
numbers that are located on the bottom of the receiver.