Water Heater; Water Heater - SAFARI Trek 2002 Owner's Manual

A thermostat located in the living room controls the furnace. Turn the furnace switch on
the thermostat to the ON position. Set the thermostat to the desired temperature. The fan
will come on and the burner should light within thirty seconds. If the burner does not
ignite, repeat the start up process. Occasionally, the furnace may not start on the first try.
There is often air trapped in the gas line that will be removed through the start up process.
After the initial start up, the furnace will operate automatically. You can control the temper-
ature using the thermostat. To shut the furnace off, set the thermostat to the OFF position.
After about two minutes the fan will stop. Keep the furnace compartment clean at all times.
Periodically check the interior and exterior vents. Do not allow them to become clogged
with debris. Avoid spraying water into the vents when washing the vehicle. Do not obstruct
the vented furnace access door.
Make sure you are familiar with the safety guidelines for all LP-Gas appliances before
using the furnace. Read through the owner's manual before operating your furnace.

Water Heater

The water heater uses LP-Gas to provide the energy to heat your water. An LP unit does
not use a pilot light. Like the furnace, it has an electronic ignition, which uses a small
amount of 12 VDC power.
The tank has a 6 gallon capacity. Before starting the water heater, fill the unit completely
with water and open the hot water tap in any location and allow the water to flow freely
for a few minutes to remove any trapped air. The LP-Gas unit has two controls - an
ON/OFF switch and a RESET light. The switch is located near the Coach Monitor Panel
above the entry. The heater has an internal thermostat that is not adjustable.
Trek Owner's Manual
3 ~ 44
050235