Max-Ox MX-900B Operator's Manual page 10

up water addition for an open-system (non-pressurized) hydronic
heating boiler.
Certificate of Limited Warranty
Max-Ox™ Wood Chip-Fired Hydronic Boilers
Warranty Exclusions (continued)
5. Service trips to your facility for instruction on how to install, operate,
or maintain the Unit, or to bring the Unit into compliance with local
codes or insurance underwriter requirements.
6. Units removed from the original installation location.
7. Damages, malfunctions, or failures resulting from failure to install the
Unit per applicable codes, or good plumbing, electrical, or HVAC
trade practices.
8. Damages, malfunctions, or failures resulting from failure to install,
operate, or maintain the Unit in accordance with the Max-Ox™ MX-
900B Operators Manual.
9. Damages, malfunctions, or failures resulting from over-firing the Unit
on combustible materials other than Approved Fuels.
10. Damages, malfunctions, or failures caused by abuse, accident, fire,
flood, freezing, lightning, or acts of God.
11. Damages, malfunctions, or failures resulting from failure to operate
the Unit without sufficient heat transfer fluid.
12. Cracks in the cast refractory that can be repaired with high-
temperature refractory joint compound.
13. Performance problems caused by improper sizing of the Unit,
improper sizing of the flue gas vent, or improper sizing of the
combustion make-up air opening requirements.
Labor, Shipping, and Processing Costs
This Limited Warranty does not cover any labor expenses for service,
repairs, reinstallation, permits, or removal and disposal of a failed Unit or its
defective component part(s). All such expenses are the owner's
responsibility.
Page 3 of 5
Max-Ox™ MX-900B Operators Manual, Rev. 0
Page 10 of 54