Power Management Setup - ECS P17G/1333 Series User Manual

Motherboard User's Guide
Serial Port1 Address (3F8&IRQ4)
Use this item to enable or disable the onboard COM1/2 serial port, and to assign a port
address.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port address.
Parallel Port Mode (ECP)
Use this item to select the parallel port mode. You can selet Normal (Standard Parallel
Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or BPP (Bi-
Directional Parallel Port).
ECP Mode DMA Channel (DMA3)
Use this item to assign the DMA Channel under ECP Mode function.
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
Press <Esc> to return to the main menu setting page.

Power Management Setup

This page sets up some parameters for system power management operation.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
*ACPI Suspend Mode
Soft-off by PWR-BTTN
PWRON After PWR-Fail
Resume On LAN
Wake-Up by PME
Power On by Ring
USB KB Wakeup From S3
PS2 Keyboard Wakeup
PS2 Mouse Wakeup
Resume on RTC Alarm
F1: General Help
*ACPI Suspend Mode (S3(STR))
Use this item to define how your system suspends. In the default, S3, the suspend mode
is a suspend to RAM, i.e, the system shuts down with the exception of a refresh current
to the system memory.This item will not show when the FSB reaches 1333MHz.
Soft-Off By PWR-BTTN (Delay 4 Sec)
Under ACPI (Advanced Configuration and Power management Interface) you can
create a software power down. In a software power down, the system can be resumed by
Wake Up Alarms. This item lets you install a software power down that is controlled by
the power button on your system. If the item is set to Instant-Off, then the power
button causes a software power down. If the item is set to Delay 4 Sec, then you have
to hold the power button down for four seconds to cause a software power down.
Power Management Setup
S3 (STR)
Delay 4 Sec
Power Off
Disabled
Enabled
Disabled
Disabled
Disabled
Disabled
Disabled
: Move Enter : Select +/-/: Value
F9: Optimized Defaults
28
Help Item
Select the ACPI
state used for
System Suspend.
F10: Save and Exit
ESC: Exit