Equipment; Boards And Options - Alcatel-Lucent OmniPCX Office RCE Small Installation Manual

Chapter
2
Note:
*: the mix of IBS DECT and IP-DECT solutions is not supported.
This hardware must be installed on the customer's site, by a qualified installer, in
compliance with the instructions provided with the hardware.
Equipment shall be installed at the factory or in the field by submitter's trained personnel
in accordance with the installation instruction provided with the equipment.
2.4

Equipment

2.4.1

Boards and Options

The following table lists the boards available on OmniPCX Office RCE Small, Medium, Large.
Board Function
APA2 2, 4 or 8 analog trunk line inter-
APA4 faces
APA8
ATA2 2 or 4 analog trunk line inter-
ATA4 faces
BRA2 2, 4 or 8 T0 basic accesses
BRA4
BRA8
PowerCPU Processing Unit (As of R8.0),
SD/MMC Memory card (2GB),
256 MB DDR2 SDRAM.
Optional Hard Drive
DDI2 2 or 4 analog trunk line inter-
DDI4 faces with Multiple Subscriber
Numbers (MSN)
LanX8 8 or 16 port Ethernet 10/100 BT
LanX16 (of which 1 or 2 10/100/1000 BT
LANX16-1 ports on LANX-2 boards)
LanX8-2
LANX16-2
2-6
Optional boards
GSCLI: Ground Start
signaling
CLIDSP: CLIP local
management
MET: pulse meter re-
ceivers (phased out)
HSL1, HSL2: intercon-
nection with expansion
modules
AFU-1: (Auxiliary Func-
tion Unit)
ARMADA VoIP32: VoIP
channels
Connections
Analog trunk line (TL), TL-
PS diversion
Analog trunk line (TL), TL-
PS diversion
ISDN network
ISDN-EFM T0/S0 forward-
ing box
Lanswitch or Ethernet ter-
minal
Please-wait message player
Tuner for background music
Alarm
Doorphone
Loudspeaker
General call ringer
ISDN-EFM T0/S0 forward-
ing box
Pulse metering device
OMC
Analog trunk line with Mul-
tiple Subscriber Numbers
(MSN)
@ Phones, Hub, Lanswitch,
PC, etc.