Overview; Installation Procedure - Alcatel-Lucent OmniPCX Office RCE Small Installation Manual

6.2.1

Overview

OMC is the PC application used to program the Alcatel-Lucent OmniPCX Office
Communication Server system via a local connection (V24 or LAN) or a remote connection
(the PC modem is connected to the Alcatel-Lucent OmniPCX Office Communication Server
integrated modem via the public network).
Three levels of programming are available using OMC:
- Easy View is used for Wizard configurations, i.e. the essential parameters for starting the
system.
- EasyPlus View is used for wizard-type configurations with the extensions offered by the
Advanced key. This key opens a window which is equivalent to Expert View.
- Expert View gives you unrestricted access to all the configuration possibilities.
The Wizard provides easy-to-use system programming, guiding the user step-by-step.
6.2.2

Installation procedure

6.2.2.1 Minimal PC Configuration
- PC requirements: see Microsoft® requirements for Windows version (XP, Vista, 7 ...)
- Windows 2003 (32 bits with SP1 or SP2), Windows 2003 R2 (32 bits with SP2), Windows
XP (32 bits with SP3 and framework.Net 2.0), Windows XP 64 bits or Windows Vista
(32/64 bits with SP1), Window 7 (32/64 bits), Windows server 2008, Windows server 2008
R2.
- Hard disk: 300 MB (recommended for installation and operation)
- Screen: 1024 x 768 pixels
- 1 mouse
- 1 serial port (connection to Alcatel-Lucent OmniPCX Office Communication Server for data
transfer)
- 1 Ethernet board (IP mode only; not required when there is a V24 serial port connection to
Alcatel-Lucent OmniPCX Office Communication Server)
- 64K (1 B-channel), or 128K (2 B-channels) PPP-compatible ISDN modem, or V34 modem
for remote access
Note:
Before installing OMC, the framework .NET must be installed.
For Microsoft Windows 8/2012, Microsoft .NET Framework 3.5 needs to be installed before installing
OMC. An internet connection is required for this installation.
To install the Microsoft .NET Framework 3.5:
-
Select on your PC the windows Feature available in Control Panel -> Programs and Features /
Programs -> Turn windows Feature on or off.
-
For Windows 8: Select the .NET Framework 3.5 check box.
-
For Windows server 2012:
•
Select Server Manager -> Manage -> Add Roles and Features wizard,
6-15