Advertisement
4. Initial Operation
Charging the battery :
0
B
5. Operation
RISK OF INJURY !
Setting the Turbotrimmer
to the working position :
D
E
C
14
The battery should be fully charged before using for the first time.
Charging time (with flat battery) approx. 10 hrs.
The lithium-ion battery can be charged in any state of charge,
and the charging process can be interrupted at any time without
harming the battery (no memory effect).
WARNING !
A
Overvoltage damages batteries and the battery charger.
8
v v Ensure the correct mains voltage.
1. Open dirt cover
0
socket
2. Plug battery charger
9
indicator lamp
The battery is being charged.
When the charging indicator lamp
is fully charged.
3. First remove the charging cable from the charging socket and
then unplug the battery charger from the mains socket.
Avoid exhaustive discharge :
Do not wait until the blade comes to an absolute stop (battery
A
totally discharged) as this shortens the battery life.
v v Charge the battery when there is a fall in the power of the
Trimmer.
If the battery has been totally discharged, the LED will flash at
the start of charging. If the LED is still flashing after an hour, a
fault has occurred (see 8. Troubleshooting).
Risk of injury if the Turbotrimmer does not switch off when
you release the start button.
V Never bypass the safety devices (by binding the start
button to the handle, for example).
Working position :
The additional handle
2
carrier
is tilted forward slightly in the working position.
1. Unscrew the tightening nut
move the additional handle
to the correct position and tighten
C
the nut
2. Unscrew the adjusting nut
set the additional handle
the correct angle and tighten
the adjusting nut
8
and insert charging cable
of Trimmer.
A
into a mains socket. The charging
B
on the battery charger lights up red.
B
D
should be adjusted so that the blade
C
,
D
by hand.
E
,
D
to
E
by hand.
9
into charging
lights up green, the battery
Advertisement
