Horizon Fitness T700 User Manual page 8

A S S E M BLY ST E P 2
HARDWARE BAG 2 CONTENTS :
LEAD WIRE
RIGHT CONSOLE MAST
CONSOLE CABLE
A Pull LEAD WIRE through RIGHT CONSOLE MAST. After
pulling the LEAD WIRE through the mast, the top of the
CONSOLE CABLE should be located at the top of the
mast. Detach and discard LEAD WIRE.
B Open HARDWARE BAG 2.
C Move RIGHT LINKAGE ARM into position and attach to
ELEVATION FRAME.
NOTE: While holding RIGHT CONSOLE MAST in the
upright position, tighten PRE-ATTACHED BOLT using
T-wrench to attach RIGHT LINKAGE ARM.
D Insert 1 BOLT (D) and 1 FLAT WASHER (E) through
RIGHT CONSOLE MAST followed by 1 WAVY WASHER (F)
and attach to MAIN FRAME.
E Lift the RUNNING DECK until lock latch on side of
treadmill is fully engaged.
F Remove CONSOLE from box and place out of the way.
G Lower the treadmill RUNNING DECK from the folded
position by stepping on LOCK LATCH on lower right side.
FLAT WASHER (E)
27 mm
BOLT (D)
Qty: 1
Qty: 1
MAIN FRAME
ELEVATION FRAME CONSOLE CABLE
WAVY WASHER (F)
29 mm
Qty: 1
RIGHT CONSOLE MAST
WAVY WASHER (F) FLAT WASHER (E)
RIGHT LINKAGE ARM
PRE-ATTACHED BOLT
*
NOTE: If you have attempted to
move the treadmill from the box
and the machine has sprung
open and cannot be assembled,
refer to the troubleshooting
section in order to restore the
treadmill to its proper position.
1
3
BOLT (D)
2