Operating Voltage - Meyer Sound Compact VariO UPJ-1P Operating Instructions Manual

APPENDIX B
Input level
AMPLIFIERS
Amplifier type
Output power
THD, IM TIM
Load capacity
Cooling
AC POWER
AC power connector
Voltage selection
Safety agency rated

operating voltage

Turn on/turn off points
Current Draw
Idle current
Max. long-term continuous
current (>10 sec)
Burst Current (<1 sec)
Note: Current draw for a single loudspeaker. Loop out not used.
Ultimate Short-Term Peak
Current Draw
Inrush Current
PHYSICAL
Enclosure
Finish
Protective grille
Rigging
Dimensions
Weight
�����
���������
24
Audio source must be capable of producing a minimum of +20 dBV (10 V rms, 14 V pk) into
600 Ω to produce maximum peak SPL over the operating bandwidth of the loudspeaker.
Two-channel complementary power MOSFET output stages (class AB)
300 W total
Note: Wattage rating is based on the maximum unclipped burst sine-wave rms voltage the
amplifier will produce into the nominal load impedance — low and high channels 30 V rms
(42 V pk) into load impedance
< .02%
4 Ω low channel, 16 Ω high channel
Forced air cooling over amplifier heatsink
PowerCon with looping output
Automatic
100 V AC - 240 V AC; 50/60 Hz
90 V AC to 264 V AC; 50/60 Hz
Note: No automatic turn-off voltages. Voltages above 265 V AC are fuse protected but
may cause permanent damage to the power supply. Voltages below 90 V AC may result in
intermittent operation.
0.41 A rms (115 V AC); 0.33 A rms (230 V AC); 0.42 A rms (100 V AC)
3.2 A rms (115 V AC); 1.6 A rms (230 V AC); 3.7 A rms (100 V AC)
5.0 A rms (115 V AC); 2.5 A rms (230 V AC); 5.8 A rms (100 V AC)
17 A pk (115 V AC); 8.5 A pk (230 V AC); 20 A pk (100 V AC)
15 A pk (115 V AC); 13 A pk (230 V AC); 15 A pk (100 V AC)
Multi-ply hardwood
Black textured
Powder-coated hex stamped steel
QuickFly rigging options
11.15" W x 22.43" H x 12.25" D (283 mm x 570 mm x 311 mm)
46.00 lbs (20.87 kg)
�����
���������
���������
����
���������
�����
���������
���������
����
���������
����
�����
���������
�����