c
3. After the IP Address, Subnet Mask, Gateway, and DNS is set up,
select Store and press
4. If you select Store without pressing the Enter button, the system will
keep the original settings.
R
—
Press
ESET
W
S
—
IRELESS
ETTINGS
wireless settings menu provides the following options:
W
—
Default option is Connected. Select Disconnected to disable
IRELESS
the wireless connection.
NOTE:
Connect.
DHCP S
ERVER
S
IP A
TART
DDRESS
address of the DHCP server to the projector connected to the wireless.
E
IP A
ND
DDRESS
the DHCP server to the projector connected to the wireless.
S
M
UBNET
ASK
G
—
Check the Gateway address with your network/system
ATEWAY
administrator if you configure it manually.
DNS—
Check the DNS Server IP address with your network/system
administrator if you configure it manually.
S
—
Press
TORE
settings.
NOTE:
1. Use
Gateway, DNS, and Store.
After the setup is complete, press the
to reset network configuration.
Select and press
It is recommended to use the default settings for Wireless
—
Allows you to enable DHCP server of the wireless.
—
Automatically or manually assigns the Start IP
—
Automatically or manually assigns the End IP address of
—
Configure the Subnet Mask of the wireless connection.
to save the changes made in wireless configuration
buttons to select IP Address, Subnet Mask,
and
http://www.pureglare.com.au
button to exit.
button to store the settings.
to activate wireless settings. The
Using Your Projector
51