Tab 'Additional Commands - Bematech MP-4000 TH Service Manual

Tab 'Additional Commands'

1. Test the printer buzzer. You can change the time the buzzer will be on and the time it will
be off. You can also select how many times you want it to be activated by typing the quantity
on the field 'Beeps'. The minimum and maximum beep values go from 0 to 63, and the time
the buzzer will be on or off can vary from 100 to 9999.
2. Interface test for the connection of the cash drawer. Selecting the option 'Activate' you will
get the current status of the drawer, 'Drawer open' or 'Drawer closed'. To open the drawer you
just need to click on the button 'Open' and the printer will then give the command to open the
drawer.
3. Choose what type of command you want to use by checking one of the two options available
('ESC/Bema' or ESC/POS®) and click on the button 'Apply' to configure the printer in the
selected option.
4. Command to activate/deactivate the buttons on the front panel of the printer. Choose one
of the options available 'Enable' or 'Disable' and click on the button 'Apply' to configure the
printer in the selected option.
5. Command to activate/deactivate the paper near end sensor. Choose one of the options
available 'Enable' or 'Disable' and click on the button 'Apply' to configure the printer in the
option selected.
6. To check the configuration of the printer use this field and click on the button 'Print' to have
them printed.
7. Adjusts the cutter activation time. The longer the time, the smaller the partial cut will be (it
may cause just total cuts). The factory default value is 10.
42