Attaching The Stand - Sharp AQuas LC-46D62U Operation Manual

Supplied accessories
Make sure the following accessories are provided with the product.
00
Remote control unit "MA" size battery
(x 1) (x2)
Page
8
Page
8
AC cord
(x 1)
Page 7
Cable Clamp (x 2)
Cable tie
(x 1)
Page 7
Stand unit
(x 1)
Page
6
Operation manual
(x 1)
CD
Always use the AC cord supplied with the
TV.
(?)
AC cord enclosed in this product is for 11 0-125V. In using it on the 125-240V AC, please consult to the follovving.
SHARP ELECTRONICS
CORPORAT~ON
6100 Blue lagoon
DrBve~
Suite 230, Miami, Florida
33126~ U.S~A.
UICK REFERENCE
@
Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
~
Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
Hex key
Long screw
e
To detach the stand, perform the steps in reverse order.
Confirm that there are 10 screws (6 short
screws and 4 long screws) supplied with the
TV.
Attach the two supporting posts for the stand
unit onto the base using the box for the stand
unit as shown below.
(Ciose-up of the upper side of the stand unit)
e
Attach the stand
un
the correct direction.
~
Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
CD
Insert the stand into the openings on the
bottom of the TV.
®
Insert and tighten the 4 long screws into
the 4 holes on the rear of the TV.
1 Insert each of the protrusions on the two
supporting posts into the openings on the upper
side of the base.
2 Insert and tighten the 6 short screws with the hex
key (supplied with the product) in the order of
CD,
@-6
®
and
@.